Report item
Item specifics
  • Model Number: Riff BOX jtag
  • Brand Name: gsmjustoncct
Product Description

EMMC Adapter for Riff BOX 
 
This adapter for riff box allows you to perform eMMC work without modifying your box !! 
 
No need to solder resistors to your riff box RJ45 port, as the resistor switch is built into the RC1000 Adapter !!
 
It allows you to connect in ISP mode (directly onto your phone without removing the EMMC) or Direct (by removing the BGA soldering and the corresponding memory fields or using adapter).
 
This special adapter allows a very simple repair of phones and tablets with blocked JTAG access (GT-i9300 / N7100 / N719 / N7102, etc.), repair phones with damaged JTAG points/pads (access to ROM2 by EMMC) or read/write EMMC applicable for the data recovery/analysis.
 
Using the adapter you can perform format EMMC or low-format (in case of damage EMMC), CMD42 Lock/Unlock/Password reset or For Samsung eMMC Factory Format.
 
Our adapter allows you to connect in ISP mode (directly onto your phone without removing the EMMC) or Direct (by removing the BGA soldering and the corresponding memory fields or using adapter).
 
You can also use this adapter and your Riff Box to direct Read / Dump the memory from the Phone EMMC Chip.
 
 
 
Advantages of the use of an adapter RC1000
 
Full control over the VCC / VCCQ by connection of external power from USB
The ability to turn ON/OFF Pull-UP CMD and DATA (Dat0) to increase signal levels and improve stability
Lack of communication problems by applying the same path length for the transmission signals
The ability to connect the IDC 10 pin connector
Allows use BGA adapters used in CHIP-Off for Direct Mode
 
 
Features
 
eMMC/SD reading info, browsing through OCR, CID, CSD (and EXT_CSD for eMMC only) registers fields, edit separate fields and writting back to card, reading/writting eMMC cards MCUs internal firmware, etc
eMMC Firmware Update option
eMMC Firmware Reading option
CMD42 Lock/Unlock functionality for eMMC - user can setremove password to protect/unprotect (lock/unclock) the User Area Partition
User Area Partition Forced Erase to erase Locked User Area Partition and to reset Device lock/unlock state and password (CMD42s consequences)
for Samsung Factory Erase which erases and re-formats for Samsung eMMC chips.
 
 
 
Output signals on the adapter
 
Note: Each of the signals is written on the the adapter itself to make work easier
 
GND
CMD (ON/OFF DipSwitch to enable/disable pullup signal - 100 ohm)
CLK
Dat0 (ON/OFF DipSwitch to enable/disable pullup signal - 100 ohm)
VCC (voltage regulation using two modes - 2.8V / 3.3V)
VCCQ (regulation voltage range in three modes - 1.8V / 2.8V / 3.3V)

 

 

Packaging Details
  • Unit Type: piece
  • Package Weight: 0.3kg (0.66lb.)
  • Package Size: 15cm x 12cm x 12cm (5.91in x 4.72in x 4.72in)
Shipping
Calculate your shipping cost by country/region and quantity.
Quantity: Ship to:
Packaging Details
  • Unit Type: piece
  • Package Weight: 0.3kg (0.66lb.)
  • Package Size: 15cm x 12cm x 12cm (5.91in x 4.72in x 4.72in)
Payment
We support the following payment methods. All payments made on AliExpress are processed by Alipay.